Your cart is currently empty.
Queen is a model-like wooden boat from the 1960s. At that time, the sports boats were still made of fine mahogany wood - like our Queen. The tried-and-tested hull shape of the two models, Classic-Sportboot and Diva, was adopted in the construction and further enlarged, as well as supplemented with a new structure. So that this model is well protected against splashing water, the side parts of the superstructure are firmly glued to the fuselage. To get to the interior, the roof of the cabin is removed and the cockpit is removed as a whole shell from the rear part of the fuselage. This model is a wooden kit with hard chines, which is a prerequisite for easy and quick assembly. All wooden parts are largely prepared and can be glued immediately after a short adjustment. The assembly takes place in the same way as with the classic sports boat and Diva: a pre-punched Depron plate serves as a heling, into which the frames are attached. After inserting the keel and the 2 longitudinal beams, the entire frame structure is already aligned. The model kit contains all the wooden parts, fittings and the ship's shaft required for construction.
Width (mm] 315
length [mm] 950
Required to complete:
1x Actro Marine ESC 30A 700342
1x Actro-n 35-4-790 brushless motor 700311
1x Servo AN-12-MGBBA Servo 700374
1x Cardan Coupling 22x4.0/5.0mm 703574
1x Propeller 3 blade, 40mm diameter, 4mm shaft 716605
NiMh or Lipo battery - 7.2V to 11.1V
Aliphatic glue, pins, clamps sharp knife, sanding block, sanding sealer, paints and varnish